5 Change the parameter value.
6 Press OK to accept the parameter change and return to view mode.
7 Perform one of the following actions and proceed to the next step:
• or to select other channel parameters.
• Press BACK to access a different channel and make any necessary programming changes.
8 Press BACK to return to Zone List Selector.
9 Press BACK to return to FPP main menu.
10
Press to return to the Home screen.
6.24.17.5
Editing Parameters
When and where to use: For all parameters except Chan Name, Zone Name, Top Chan Name and
Top Zone Name the or buttons increment or decrement the selected value by scrolling through
the valid entries.
Procedure:
1 Perform the following actions based on the type of the parameter:
Table 5: Parameter Editing Keys
Parameter Editing Keys Value
Tx Perform one of the following:
• or to increment entry and to move cursor.
Rx
Tx PL Perform one of the following:
• or to increment entry and to move cursor.
DEL to delete the parameter value of PL entered.
In addition, for Tx DPL and Rx DPL, the INVT softkey switches INVERT on
and off.
Rx PL
Tx DPL
Rx DPL
Tx NAC
or to increment or decrement entry and to move cursor within parameter
value.
Rx NAC
Rx Type Perform one of the following:
• or to toggle between valid entries.
ANALOG/
DIGITAL/
MIXED
Tx Type ANALOG/
DIGITAL
Bandwidth 25kHz/
20kHz/
12.5kHz
Protect ON/OFF
Tx Deviation 5.0 kHz/4.0
kHz/2.5 kHz
Power Level High/Low
Hot Keypad ON/OFF
MN004863A01-AG
Chapter 6: Advanced Features
107
To Next Page
Loading...
