Upgrading Your Radio
FLASHport User’s Guide
8
Upgrading Your Radio
Upgrading Your Radio Using CPS
This section provides instructions on how to upgrade or
“FLASH” your radio with new features using the Customer
Programming Software (CPS).
“FLASHing” Procedure (CPS)
“FLASHing” or upgrading your radio requires the Customer
Programming Software (CPS) which is used during normal radio
programming and servicing procedures. Refer to the “Getting
Started” section for your radio’s specific CPS part number. The
following steps describe the best method to upgrade your radio.
Note: To save time, perform upgrades of the same model type
consecutively. (Example: XTS 5000 Model 1 radio followed
by an XTS 5000 Model 1 radio.)
1. Your FLASHport software upgrade package includes one
piece of software (FLASHport upgrade software) on CD-ROM.
Before starting the upgrade procedure, copy the software to
your PC hard drive.
2. Connect the equipment as shown on page 7 of this guide.
Make sure the radio is equipped with a charged battery
(portables) or an external power supply (mobiles).
3. Apply power to the radio. The radio should turn on and go
through its power-up sequence.
Note: Do not disconnect your radio until the FLASHport upgrade
process is completely finished.
94C35_Book.book Page 8 Thursday, June 2, 2005 3:10 PM
To Next Page
Loading...
Need help?
General