1 - 2 CONNECT
3 - 4 PAIR
5 TEST AND
USE
Get Connected in
5 Quick Steps
DC800
Bluetooth®
Home Stereo Adapter
Follow the numbered steps to connect
and use a Motorola Bluetooth
®
DC800
Home Stereo Adapter.
Note: The DC800 Home Stereo Adapter is
a Class 1 Bluetooth device. Bluetooth
features and Bluetooth Class 1 power
levels are not allowed for outdoor operation
in France. To avoid unlawful interference
with radio signals, do not use the Bluetooth
features in France unless you are indoors.
Note: To operate with the DC800 Home
Stereo Adapter, your Bluetooth audio
device must support A2DP Profile
capability.
Note: To maintain compliance with RF
exposure guidelines, you must keep the
DC800 Home Stereo Adapter at least 20
centimeters (8 inches) away from any
person.
Before using this product, read the Important Safety and Legal
Information pamphlet and follow its instructions.
Audio Out
Jacks
Audio In
Jacks
Make the following audio connections to your
stereo adapter (using the supplied cables):
Connect the Audio Out jacks on the stereo
adapter to unused Audio In jacks on your
home stereo system.
Connect the Audio In jacks on the stereo
adapter to unused Audio Out jacks (such as
Tape Out) on your home stereo system.
Note: If your home stereo does not support Line Out audio,
you may have to connect through the headphone jack with
the included RCA-to-headphone cable.
Note: To stream music from your phone (when equipped
with 2.5mm stereo output jack), use the included RCA-to-
2.5mm cable to connect to the adapter's Audio In jacks.
1
2
1
AUDIO
CONNECTIONS
2
POWER
CONNECTIONS
Plug the included AC power supply into
the Power Jack on the stereo adapter.
Plug the other end of the AC power supply
into a wall outlet.
1
2
Make the following power connection to
your stereo adapter:
Power Jack
To Next Page
Need help?
General
