Motorola DLR1020 - Setting Radio Profile ID (PIN)

English
38
ADVANCED RADIO
CONFIGURATION
“programming tone” sounds and you hear the
voice announcement “Programming Mode,
press Menu to continue”.
Note: The Tx/Rx Indicator LED blinks a steady red
heartbeat during the Programming Mode.
3. Short press the Menu button to navigate along
and loop through the different programmable
features available:
• Profile ID Number,
• Maximum Channels,
• Programmable Top Button Options, and
• Microphone Gain.
4. The voice announcements indicate the menu
features and their current settings. To modify
the settings, press the (+) or (-) buttons.
To exit the Advanced Radio Configuration
Mode:
1. Press and hold the PTT button until a “beep”
sound is heard.
Setting Profile ID Number (PIN)
While in Programming Mode:
1. Press the Menu button to hear the voice
announcement “Current Profile ID <####>, to
change press (+) or (-)”.
Note: User must advance through all 4 digits
before new Radio PIN will be saved.
2. Press the (+) or (
-) button to start setting the
Radio PIN. The voice announces “First digit
<#>, to change press (+) or (-)”. Short press the
(+) or (-) button until you reach the desired
number. Numbers loop from 0 – 9.
3. To move to the next digit, short press the Menu
button. The voice announces “2nd digit <#>, to
change press (+) or (-)”.
4. Repeat Step 2 and 3 until all 4 digits are set and
you hear the voice announcement “Profile ID
saved as <####>, press Menu to continue”.
5. Press the Menu button to continue to the next
programmable feature available.
Note: If you are done programming, press and
hold the PTT button until a "beep" sound is
heard, to exit the programming mode.