47
CUSTOMER PROGRAMMING
SOFTWARE (CPS)
Radios OFF and ON or, long press the PTT
button to exit the ‘cloning’ mode
What To Do If Cloning Fails
The radio audible voice will announce “Fail”
indicating that the cloning process has failed. In
the event that the cloning fails, perform each of
the following steps before attempting to start
cloning process again:
1. Ensure that the batteries on both radios are fully
charged.
2. Check the cloning cable connection on both
SUCs and the cable is switched to “Cloning”.
3. Ensure that the battery is engaged properly on
the radio.
4. Ensure that there is no debris in the charging
tray or on the radio contacts.
5. Ensure that the Target radio is turned ON.
6. Ensure that the Source radio is in cloning mode.
7. Ensure that the two radios are both from the
same type (i.e.:DLR series), same region and
have the same transmission power.
Note: This cloning cable is designed to operate
only with compatible Motorola SUC
PMLN7139_.
When ordering Cloning Cable Kit, please refer
to P/N# HKKN4028_. For more information
about the accessories, refer to “Accessories”
on page 57.
To Next Page
Loading...
