2 Place the Source Radio in its SUC. Press and
release the Volume Up button.
You hear "Pass" or "Fail" voice prompt from your
Source Radio.
7 To exit the Clone Mode when the process is
completed, press the Power button, or long press
the PTT button.
11.4
Troubleshooting Cloning Mode
In the event that cloning fails, perform each of the following
steps before attempting to start cloning process again.
1 Ensure that the batteries on both radios are fully
charged and engaged properly on the radio.
2 Check the cloning cable connection on both Single
Unit Chargers (SUC and if the cable is switched to
“Cloning”.
3 Ensure that there is no debris in the charging tray or
on the radio contacts and the radio contact is
touching the SUC/MUC contact firmly.
4 Ensure that the Target Radio is turned on.
5 Ensure that the Source Radio is in cloning mode.
6 Ensure that the two radios are both from the same
frequency band, same region and have the same
transmission power.
NOTICE:
This cloning cable is designed to operate only
with compatible Motorola Solutions SUC
PMLN8034_.
When ordering cloning cable kit, refer to part number
HKKN4028_. For more information about the accessories,
see Accessories on page 87.
11.5
Cloning Mode Using Wireless
PROFILE ID Number
The PROFILE ID Number Wireless Cloning feature is
useful when you want to clone the PROFILE ID Number for
all the radios in your fleet, but you do not want to clone
particular radio settings that may be unique for each radio
such as Top button configuration, MIC Gain, Radio Name.
English
80
To Next Page
Loading...
