Motorola DLR1060 - Configuring Cloning Mode Using Wireless PROFILE ID Number

Wireless PROFILE ID preserves each user radio setup, but
still ensure that all radios are under the same PROFILE ID
Number. This feature is useful if you do not have a
programming Cable, Cloning Cable or PC easily available.
11.5.1
Configuring Cloning Mode Using
Wireless PROFILE ID Number
1 Turn the Source Radio on by performing the
following actions:
a Press PTT → Volume Down buttons at the same
time while turning the radio on.
b Wait three seconds before releasing the buttons
until you hear “Clone Mode Serial” voice prompt
from the Source Radio.
c Press and release the Volume Down button.
You hear "Wireless" from the Source Radio.
2 Turn on the Target Radio by performing the following
actions:
a Press PTT → Volume Down buttons at the same
time while turning the radio on.
b Wait three seconds before releasing the buttons
until you hear “Clone Mode Serial” voice prompt
from the Target Radio.
NOTICE:
Avoid putting powered on radios (more than
seven radios) in a container together, other
than the Multi-Unit Charger.
3 To start the wireless PROFILE ID Number cloning on
the Source Radio, press and release the Volume Up
button.
• You hear a tone.
• After cloning is completed, you hear "Pass"
indicating cloning is successful or "Fail" indicating
cloning failed voice prompt from the Source
Radio.
• On the Target radio, the radio receives the
PROFILE ID Number information. You hear
"Pass" indicating cloning is successful or "Fail"
indicating cloning failed voice prompt from the
Target Radio.
English
81