To Next PageTo Next Page
Need help?Do you have a question about the Motorola DSR-6401 and is the answer not in the manual?
Lists the main capabilities and characteristics of the DSR-6400 Series.
Explains how different models of the DSR-6400 Series vary in service capacity.
Details the PID values for the ASI OUT 1 port.
Details the PID values for the ASI OUT 2 port.
Lists the items included in the shipping carton.
Provides instructions for installing the unit in an EIA equipment rack.
Details how to connect the unit to GigE, ASI, or RF signals.
Explains how to configure the unit for remote operation via web browser.
Explains how the front panel LCD screen displays menus and fields.
Details how to use the keypad buttons to navigate through menus.
Explains the About Menu and Main Menu structure.
Allows signal acquisition by selecting frequencies or inputs.
Specifies how to set the ASI input port.
Specifies how to set the GigE input port.
Selects RF input ports for signal acquisition.
Selects the modulation mode (DCII-AUTO, DCII-MAN, DVBS2).
Sets symbol rate, code, and format for modulation.
Chooses which port to configure (1 through 8).
Selects the mode for port setup (Auto or Manual).
Selects a satellite name for the designated port.
Selects the polarity for the designated port.
Directs power to the external Low Noise Block (LNB).
Selects audio processing options (Stereo, Dual Mono, Mono, Surround).
Enables/disables dialog normalization and controls audio level compression.
Sets the mode for audio gain (always Joint).
Adjusts output levels of left and right audio signals.
Selects the trigger condition to activate an alarm.
Provides an IRD alarm test.
Chooses the purpose of the fourth relay (Alarm or Ad Insertion).
Enables or disables the ASI OUT 1 on the back panel.
Selects the data rate (Mbps) for ASI OUT 1.
Selects the data rate (Mbps) for ASI OUT 2.
Selects reset type: No, Factory Defaults, or Power Cycle.
Manually upgrades or reverts the unit to a different code version.
Adjusts the front-panel LCD contrast.
Selects output format for 525-line video (NTSC or PAL-M).
Selects output format for 625-line video (PAL-625 or PAL-N).
Displays unit's firmware release information.
Monitors the status of the current code download.
Views or selects active VCTs, Virtual Channels, and transponder names.
Specifies MPEG program numbers as an alternative to VCT/Channel.
Modifies and views language status for audio outputs.
Modifies and views the status of video subtitles language.
Sets and views the IP address for the Ethernet port.
Sets and views the GigE IP output address.
Selects transport streams routed to the GigE port.
Displays health and alarm trigger status.
Displays video encoding configuration for SD programs.
Displays video encoding configuration for HD programs.
Displays Inbox mail messages with delivery timestamp.
Enables or disables on-screen diagnostics.
Displays different test patterns for video diagnostics.
Lists contact channels for assistance with Motorola products.
Provides instructions and contact information for sending units for repair.
Explains the purpose and format of Fast Facts screens.
Guides on how to access and navigate the OSD diagnostic screens.
General
