5
PID Mapping
The DSR-6402 uses a PID mapping scheme for the output services on the ASI OUT 1, ASI OUT 2, and
GIGE output ports. The following two tables show the supported services and each of the individual
service components for the DSR-6402, and their assigned PID values on each MPEG program. For
multiple instances of the same component type, the unit increments the PID value by one.
ETHERNET
10 / 100
ASI IN ASI OUT 1
VIDEO OUT
OSD VIDEO OUT
ASI OUT 2
GIGE
PID Assignments: ASI OUT 1 Port, DSR-6402
Processor
Path
Output MPEG
Program
Number
Format
PMT Video Audio1 Audio2 DPI DSMCC Subtitle
11
Decimal 256 272 288 289 304 320 336
Hex 100 110 120 121 130 140 150
22
Decimal 512 528 544 545 560 576 592
Hex 200 210 220 221 230 240 250
PID Assignments: ASI OUT 2 Port, DSR-6402
Processor
Path
Output Program
Resolution
Transcoded
From
Number
Format
PMT Video Audio1 Audio2 DPI DSMCC Subtitle
PR1 HD
ASI1
Program 1
Decimal 512 528 544 545 560 576 592
Hex 200 210 220 221 230 240 250
PR2 HD
ASI1
Program 2
Decimal 1024 1040 1056 1057 1072 1088 1104
Hex 400 410 420 421 430 440 450
Note: The GIGE port
carries the same PID
mapping information
as the two ASI OUT
ports.
If You Have Trouble
If after carefully performing the procedures in this guide you are unable to acquire and decode
the desired signals, or if you are having other performance issues with your equipment, please
contact the Discovery project desk at (800) 308-6272. The project desk is available from 8 a.m.
to 8 p.m, Eastern Time.
the tuned network.
E
STATUS5
Sync Eb/No Authorize State
Locked
+12.3
Subscrbd With Tape
This completes the initial powering, connection and authorization of this DSR-6402. Additional reference
information on PID Mapping, Support, and Antenna Considerations is presented on the following pages. For
further information on operating the DSR-6402 and configuring it for remote operation, please consult the
DSR-6400 Series Operator’s Guide.
To Next Page
Loading...
