Programming Mode 4-13
TOC-XXX Turn Off Code/
Reverse Burst
TOC-OFF,
TOC-ON
TOC-ON ¥ TOC or Reverse Burst serves to cause the receiv-
ing radio to mute its speaker before a loss of carrier
is detected.
¥ If enabled (ON), Turn Off Code will be sent if Tx
DPL is enabled for the channel (Reverse Burst for Tx
PL).
¥ Press + or - to select ON or OFF.
XXX-POWR Power Level HI-POWR,
LOW-
POWR,
ECO-
POWR, RX
ONLY
HI-POWR ¥ Select the power level required for the channel.
¥ HI-POWR transmits at the maximum tuned power.
LOW-POWR is typically 1W and ECO-POWR, less
than 500mW. Set to RX ONLY if the channel is
intended as a Receive Only Channel.
¥ Press + or - to select the desired Tx power level.
BCL-XXX Busy Channel
Lockout
BCL-OFF,
BCL-ON
BCL-OFF ¥ Select if the channel is to enable Busy Channel
Lockout (BCL).
¥ If BCL is enabled, the channel will check for chan-
nel activity before you can transmit. Detection of
channel activity which is not from the same group
would prevent radio from transmitting.
¥ Press + or - to select the desired BCL setting.
CH-TAG Channel Alias 0,1,É.,9, A,
B, É., Z, +,
-, /, *, #,
Space.
Blank ¥ Allows the channel number to be displayed as alias.
¥ Press + or - to move to the character that needs to
be edited. Enter the character using the keypad.
¥ Refer to "4.10.2 Entering a Channel Alias" on page
20 for details.
CS Ð XX.X Channel Spac-
ing
CS Ð 12.5,
CS Ð 25.0
CS Ð 25.0 ¥ Select the channel spacing for the channel.
¥ Press + or - to select the desired channel spacing.
SC-XXX Selective Call
(Selcall)
SC-OFF,
SC-ON
SC-OFF ¥ Select if Selcall is to be enabled or disabled.
¥ If enabled, the channel would adopt Signaling
Squelch Mode, i.e., unsquelch only if radio is receiv-
ing carrier AND Selcall (matching ID).
¥ Press + or - to select the desired Selcall setting.
ACK-XXX Acknowledge-
ment Enabled
for Individual
Call
ACK-OFF,
ACK-ON
ACK-OFF ¥ Select if Acknowledgement is to be sent upon
receiving an Individual Call.
¥ If enabled, the preprogrammed Ack ID will be
replied once the Individual Call is received and car-
rier loss is detected.
¥ Press + or - to select the desired acknowledgement
setting.
PID-XXX PTT ID PID-OFF,
PID-ON
PID-OFF ¥ Select if PTT ID is to be sent upon PTT press.
¥ If enabled, PTT ID would be sent according to the
PTT ID Transmit Type selected in RW.
¥ Press + or - to select the desired PTT ID transmit
setting.
Channel
Parameter
Description Range
Default
from
Factory
Remarks
To Next Page
Loading...
Need help?
General
