SCAN
35
English
SCAN
This section outlines the scan functions of your radio.
All references to what is shown on the display is only
valid for GP580 radios. Throughout this section, the
display below
is used to indicate the radio’s home display.
SCAN OPERATION
The scan feature allows you to monitor activity on
different conventional or trunked modes by scanning a
scan list of modes. This list can be programmed with
the Customer Programming Software (CPS) or user
programmable.
Three types of scan operation are available depending
on radio model.
Your radio may support both priority and non-priority
scanning. With priority scanning enabled, a scan list
can have one mode assigned as the first priority mode,
and a second as the second priority mode.
Automatic scanning (autoscan) can be programmed
through the CPS. If autoscan is enabled for a mode,
your radio begins scanning, using the mode’s scan list,
whenever you select that mode. The radio will
continue autoscanning until you select a mode that
does not have autoscan enabled.
Turning Scan On or OFF with the Keypad
(GP580 radios only)
Trunking
Priority Monitor
Comprises modes that are all from the
same trunked system.
Conventional Comprises conventional-only modes.
Talkgroup
Scan
Comprises conventional modes and
trunked modes from more than one
trunking system. Priority operation is
NOT available in this type of list.
PLANT POLICE
1. Press / until
SCAN is displayed.
2. Press ; (the soft-
key below SCAN).
You will see the cur-
rent scan state
momentarily.
or
Then
PHON SCAN CALL
SCAN ON
SCAN OFF
ON
OFF
UG_540_580 _EN.fm Page 35 Wednesday, August 14, 2002 10:13 AM
To Next Page
Loading...
