SCAN
38
English
Scan Modes
When programming the scan list, each member can
be given one of several scan modes. The following
table lists the scan mode cycle activated by
subsequent presses of the select key.
Note: There can only be ONE Priority 1 member
and ONE Priority 2 member in a scan list. Thus,
if there is already a Priority 1 member in the
scan list, changing another member’s mode to
Priority 1, would automatically cause the
previous member’s mode to be changed to a
Scan Member. This same behavior is also seen
when programming the Priority 2 member.
Initial Scan
Mode of Member
Number of Times the Select Key is Pressed
1234
Priority 2*
Priority 1* Non Scan Member Scan Member Priority 2*
Priority 1*
Non Scan Member Scan Member Priority 2* Priority 1*
Non Scan
Member
Scan Member Priority 2* Priority 1* Non Scan Member
Scan Member
Priority 2* Priority 1* Non Scan Member Scan Member
* Priority options are only available if enabled.
UG_540_580 _EN.fm Page 38 Wednesday, August 14, 2002 10:13 AM
To Next Page
Loading...
