STAT-ALERT
FEATURES
57
English
Initiating a Voice Selective Call
Entering the Desired Radio ID Number
If the last ID number called is the desired number,
go directly to step 5.
To enter a new number
Note: Once you have started entering numbers,
the , key functions as a backspace key.
Pressing it causes the last digit entered to be
erased, and the cursor moves to the left. When
the last digit is erased, an additional press of this
key causes the last ID number transmitted or
received to be displayed; pressing / shows
the first member of the list.
• If automatic Selective Call is enabled, your
radio will remain in Selective Call until you exit
the mode. If automatic Selective Call is disabled
in your radio, the radio will immediately exit
Selective Call when you release the PTT.
• In both Selective Call and Call Alert, a * will
match any number in the ID position. For exam-
ple, paging ID 000* will page all IDs from 0000-
0009. Paging **** will page all radios on the
system.
To enter a number from the call list
1. Press / until CALL is
displayed.
2. Press l (the softkey below CALL).
3. The display shows the
last ID number
transmitted or received.
4a. Enter the new four-digit ID number using the
keypad.
4b. On the display, the old ID number disappears
and the new digits appear as they are being
entered.
4c. The cursor flashes indicating the location of
the next number to be entered.
ZONE MUTE CALL
ID: 2350
4a. Press either , or /.
4b. / takes you forward to the first or next
member of the list; , takes you backwards
to the last or previous member of the list.
4c.
When at a member of
the list, the display
alternates between
showing the member’s
name and ID number.
Alternates between
and
CW NORTH
ID: 2350
UG_540_580 _EN.fm Page 57 Wednesday, August 14, 2002 10:13 AM
To Next Page
Loading...
