19
English
Charger is in Discharge/Reconditioning Mode
LED Steady YELLOW
Line 1 DISCHARGE
Line 2
Charger is Calibrating an IMPRES Battery
LED Steady YELLOW, Steady RED, & Flashing YELLOW or
GREEN
Line 1 Calibrating
Line 2 Battery
LED Steady GREEN
Line 1 Battery
Line 2 Calibrated
* All IMPRES batteries should be calibrated before initial use. An IMPRES
charger will automatically initiate calibration for all new batteries
Battery Capacity Data is Displayed as “%” in mAH, and Voltage
LED Defined by Charge State
Line 1 ----% RATED CAP.
Line 2 ----mAH --.-V
Estimated Capacity After Charge
LED Defined by Charge State
Line 1 EST CAP AFTER
Line 2 CHARGE xx%
Estimated Time Required to Complete Rapid Charge
in Hours, Minutes for NiCD & NiMH IMPRES Batteries Only
LED Defined by Charge State
Line 1 RAPID CHG ENDS
Line 2 IN xx HRS, yy MIN
03_09L67-C_Addendum.fm Page 19 Thursday, February 24, 2005 5:34 PM
To Next Page
Loading...
