What does 'Data Server Unavailable' mean on my Motorola Cell Phone?
If you launched the micro-browser on your Motorola Cell Phone and the display says 'Data Server Unavailable,' try again in a few minutes. The servers may be temporarily busy.
Why doesn't my Motorola M900 ring?
If your Motorola Cell Phone does not ring, the ringer might be set to low. Raise the volume using the VOL UP DOWN keys.
How to turn off Motorola Cell Phone if power key doesn't work?
Press and hold the Voice Activation key and the volume down key for one second if you can not turn the Motorola Cell Phone off with the POWER OFF key and switching the power switch to OFF.
Why can't I send or receive calls on my Motorola M900?
If you cannot send or receive calls on your Motorola Cell Phone, make sure your antenna is fully extended and that you have a phone signal. Avoid areas with electrical or radio interference, and obstructions such as bridges, parking garages, or tall buildings.
Why does my Motorola M900 Cell Phone have poor reception and drop calls?
If your Motorola Cell Phone has poor reception and drops calls, ensure your antenna is fully extended and not bent or damaged. Also, make sure you have a phone signal. Stay clear of obstructions like bridges, parking garages, or tall buildings.
Why does my Motorola M900 say 'Service Not Available' when using micro-browser?
If you launched the micro-browser on your Motorola Cell Phone and the display says 'Service Not Available', you may be in an area without service. If you have wireless service, look in the display for the digital signal indicator. If you do not see the indicator, you may be in an area that has only analog service or no service at all. If you see the digital signal indicator, you may be connected to a digital network that does not support Internet access.
What to do if Motorola Cell Phone doesn't beep when connecting data cable?
The beep indicates that you are set up correctly. If you did not hear a beep when you plugged the data cable into your Motorola Cell Phone, make sure that both ends of the data cable are connected - the smaller end to your phone and the larger end to your computer. Also, your computer may have deactivated the port to save power. Try opening an application that uses the port, like a fax or dial-up application, to automatically activate the port.
Why don't data/fax apps work on Motorola Cell Phone after connecting data cable?
If your Motorola Cell Phone beeped when you attached the data cable, but your data and fax applications don’t work, you must be in an area with digital coverage. Check your phone’s display for the digital signal indicator. Some wireless networks may not support data or fax transmission. If you see the digital indicator, but you are roaming on an unfamiliar network, this may be the case. Also, remember that data and fax transmission usually requires a subscription. Call your service provider for more information.
How to increase earpiece volume on Motorola Cell Phone?
If the earpiece volume on your Motorola Cell Phone is too low, press the upper volume key on the side of your phone while on a call.
Why does my Motorola M900 Cell Phone make a high/low tone when I try to call?
If you tried to place a call and heard an alternating high/low tone on your Motorola Cell Phone, it means your call didn't reach the wireless system. This can happen if you dialed the number too soon after turning on the phone. Wait until the display says 'Ready' before making a call.
General| Announced | 2005 |
|---|---|
| Status | Discontinued |
| SIM | Mini-SIM |
| Display Type | Monochrome graphic |
| Phonebook | 500 entries |
| Alert types | Vibration; Downloadable polyphonic ringtones |
| Loudspeaker | No |
| 3.5mm jack | No |
| Antenna | External |
| Messaging | SMS, EMS, MMS |
| Clock | Yes |
| Alarm | Yes |
| Games | Yes |
| Network | GSM |
To Next Page
