MaxTrac 100/300 Operation
MAEPF-22597-O
6
Turning the Radio On
To turn the radio on, rotate the On/Off Volume knob clockwise until it clicks. A
short chirp tone will be heard if the radio passes the radio self-check test. The
last channel used before the radio was turned off will be displayed. The radio is
now in standby mode and ready to receive or transmit.
Note: The radio should be turned off whenever the engine is off to avoid draining
the vehicle battery.
Radio Self-Check
Every time the radio is turned on (power-up), it performs a functional self-check
and, if necessary, will sound a 5-second warning tone instead of the short chirp
tone normally heard at power-up. This is an indication that the radio is no longer
operating at the exact parameters set in the factory or field and should be
serviced immediately.
6 MaxTrac 100/300 Operation
Turning the Radio On /
Radio Self-Check
MaxTrac
ON/OFF
VOLUME
MODE
UP
TRANSMIT/BUSY
LED
MONITOR
LED
PRIORITY
LED
MICROPHONE
CONNECTOR
MODE
DOWN
MONITOR
SCAN
SELECT
BLANKER DISABLED
(SEGMENT ON LOWBAND ONLY)
MAEPF-22597-O
MaxTrac 300 (16-Channel) Model
To Next Page
Loading...
Need help?
General