Getting Started 9
ENGLISH
2.2 Parent unit battery installation
The parent unit comes with a battery pack. Charge the battery in the parent unit
before you use it for the first time or when the parent unit indicates that the
battery is low.
1. Turn the belt clip so that it is in the hanging position.
2. Slide off the battery compartment cover.
3. Insert the wired plug of the supplied battery pack into the small socket as
shown above, and fit the battery pack into the compartment.
4. Replace the battery compartment cover.
5. Insert the small plug of the power adapter into the socket on the side of the
parent unit.
6. Connect the other end of the power adapter to the mains socket.
7. The Charging Indicator comes on.
NOTE
Only use the provided power adapter.
To Next Page
Loading...
