Motorola MC3090-Z - Scanner Not Reading Barcodes

Possible Cause 2
The RFID tag is unreadable.
Solution
Replace the tag.
Possible Cause 3
The RFID tag is out of range.
Solution
Lower the distance between the reader and tag.
Possible Cause 4
The RFID tag is not compatible with the reader.
Solution
Only RFID tags supplied or supported by WinWare should be used.
Possible Cause 5
Battery power is too low.
Solution
Recharge the battery.
The scanner is not reading barcodes
Possible Cause 1
The barcode scanning application is not installed.
Solution
Contact WinWare support.
Page 5 of 6
© 2010 WinWare, Inc. All ri
g
hts reserved. CS–SCR-001-08312010