Minitor IV Pager Programming Guide
Getting Started
The first command required to program the pager is the “Read” command. It can
either read from a pager or an archived files. After the Read command, user can
view/modify the codeplug data, save the codeplug data to a file, or write directly
to a pager.
Figure 6 Minitor PPS available commands after “READ” operation
System Setup
If you encountered a problem reading codeplug directly from a pager, your
serial communication port (RS-232) may not be set correctly. You need to
execute the System Setup command to configure your system.
Figure 7 System Configurations
Group Field Name Description
Communication Port
(COM1, COM2,
COM3, COM4,
COM5, COM6,
COM7 and COM8)
Select the communication port
which is connected to your
programmer kit
Communication
Setting
Baud Rate This is a non-editable field with
fixed baud rate 1200 bps.
Table 2 System Configurations
6880309M81-A 9/20/2004 7
To Next Page
Loading...
