Motorola MOSCAD - User Manual

68P02958C52-O
@6802958C52@
ã Motorola Inc., 2000 May 2000
MOSCAD
TM
, MOSCAD-L
& MOSCAD- NFM
Ethernet Interface Option
Owner's Manual
Introduction
The Ethernet interface option is used as a communication link for the MOSCAD, MOSCAD-L and
MOSCAD- NFM units with Local Area Networks (LAN).
The Ethernet interface option supports TCP/IP protocol on a TWISTED PAIR (TP) connector, with
automatic polarity correction.
The Ethernet interface option is available in the following hardware configurations:
Ethernet Plug-in Option
Enclosed in the CPU modules of the MOSCAD and MOSCAD-L, the Ethernet Plug-in provides direct
connection to LAN. When Ethernet Plug-in board is installed, Port 3 serves for Ethernet connection. Use
shielded cable for LAN connection. Install suppression core (Fair-Rite
P.N 044316415)onthecableusedfor
LAN connection, as shown in the figure below.
/ Note: Due to physical limitations, the Ethernet Plug-in board cannot be installed in MOSCAD CPU
module that is already configured with a memory expansion board.
MOSCAD CPU Module with
Ethernet Plug-in Option
MOSCAD-L CPU Module with
Ethernet Plug-in Option
a
Port 3
Ethernet
connection
Ethernet Plug-in board
To LAN
Suppression
Core
(Fair-Rite)

Summary

Introduction to Ethernet Interface Option

Ethernet Plug-in Option Overview

Details the Ethernet Plug-in board for MOSCAD/MOSCAD-L LAN connection, using Port 3.

External Ethernet Unit Option

External Ethernet Unit Front Panel Features

Describes the front panel components and indicators of the external Ethernet unit.

Connecting External Ethernet to MOSCAD Unit

MOSCAD Unit Connection Diagram

Illustrates how to connect the external Ethernet unit to a MOSCAD CPU module.

Mounting Ethernet Unit in MOSCAD Box

Shows mounting locations for the Ethernet unit within the MOSCAD enclosure.

Connecting External Ethernet to MOSCAD-L Unit

MOSCAD-L Unit Connection Diagram

Details the connection of the external Ethernet unit to a MOSCAD-L CPU module.

Mounting Ethernet Unit in MOSCAD-L Box

Illustrates the two mounting locations for the Ethernet unit in the MOSCAD-L box.

Connecting External Ethernet to MOSCAD-NFM Unit

MOSCAD-NFM Unit Connection Diagram

Shows the connection of the external Ethernet unit to the MOSCAD-NFM.

Mounting Ethernet Unit on MOSCAD-NFM Rack

Details the mounting bracket and locations for Ethernet units on MOSCAD-NFM 19" racks.

Upgrading Ethernet Unit and Plug-in

Ethernet Unit Upgrade Procedure

Explains upgrading the Ethernet unit/plug-in using ToolBox System Downloader.

D-type Adapter Configuration Table

Provides pin configuration details for the D-type adapter used in upgrades.

Motorola MOSCAD Specifications