Motorola Mobility Confidential Restricted:
PAGE 54 Do not share without consent from Motorola
Front housing to Rear Housing Assembly
24. Assemble Rear housing and front housing.
Assembly sequence refer to the photo.
25. Screw the 8 IP5 Torx Screws first to lock the
Rear Housing.
Use the Torque Driver and IP5 Torx bit to
tighten the 14x 5IP screws to 0.9 in-lbs in the
order shown.
Screws should be tightened in the following
order:
a. Four Upper Screws. _M1.4*4.1
b. Four Lower Screws. _M1.4*4.1
c. Remaining 6 middle Screws.
_M1.4*3.0
To Next Page
Loading...
