Motorola Mobility Confidential Restricted:
PAGE 9 Do not share without consent from Motorola
PSCD Gaps
All dimensions are in millimeters (mm). The following gaps are considered maximum allowable without further approval.
Gaps measured with Pin Gauges must be done perpendicular to the surface/area being measured. Pin Gauges must not
be used at an angle as they will give false-positive results due to visual objectivity.
Table 2. PSCD Gap Measurements
The gap around the cover glass to the front housing
The step between front housing and cover glass at top and
bottom side
Cover glass recess Min: 0.05mm
The step between front housing and cover glass at center
of left/right side
cover glass recess Min:0mm
The step between front housing and speaker trim
Cover glass recess Min: 0.05mm
The step between front housing and speaker trim
Cover glass recess Min: 0.05mm
The gap around front housing and speaker trim
The gap around front housing and speaker trim
The gap around the rear cover and camera trim
The step between the rear cover and camera trim
The gap around the camera trim and camera lens
Concentricity between imager center eye to camera lens
artwork
The gap around rear cover and flash lens
The step between rear cover and flash lens
The step between front housing and rear cover
The gap between the front housing and volume key
The gap between the front housing and the power key
The gap between the rear cover and volume key
The gap between the rear cover and the power key
The gap between the front housing and the rear cover
The gap between the micro USB and rear cover
The gap between the front housing and the HSJ trim
The gap between the rear cover and the HSJ trim
Concentricity between imager center eye to lens artwork
Parallelism of screen and lens artwork in X
Parallelism of screen and lens artwork in Y
To Next Page
Loading...
