Motorola MT7711 - Page 43

43
To configure and enable a Guest Network on the 2.4 GHz band, first select
the 2.4 GHz tab, and then:
1 Select the desired Guest Network (there are two available for
each band).
2 Click the Save button.
3 Select Enabled and click Save to enable the selected Guest
Network.
The following steps are optional. Follow them if you want to change the
default Guest Network Name and Password:
4 Select and delete the old Guest Network Name, then type in the
new Guest Network Name and click Save.
5 You can click the Show Key box to check your typing for
Password.
6 Select and delete the old Password, then type in the new
Password.
7 Click the Save button.