Motorola MT7711 - If You Need to Support WEP

73
If you need to support WEP, follow these steps.
1. Disable all WPA, WPA-PSK, WPA2, and WPA2-PSK entries.
2. Make sure to click Save for each entry you change.
3. Under 802.11n Mode Enable/Disable, select Disable from the pulldown.
4. Click Save.
5. Find the tab WEP Security Settings.
6. In the field PassPhrase, enter a sequence of letters. This can be words,
names, or an arbitrary sequence.
7. Click the button Generate WEP Keys.
8. In the WEP Encryption pulldown, select either WEP-64 bit or WEP-128
bit. (WEP-128 offers more security).
9. Select Enabled on the Show Keys pulldown.
10. Note the setting of Current Network Key. This determines which
Network Key you need to use on your clients. You can change this value
by selecting a different number in the pulldown.
11. Click the Save button at the top of the WEP Security Settings box.
12. Note the Network Key that you selected, and save this for use on your
clients. (Also store a copy in a safe place, such as on a piece of paper
taped to the bottom of your device).