QIP2500 User Guide
5
INTRODUCTION
Item
Description
1
RF IN – Connects to and receives a cable signal from your service
provider
2
TO TV/VCR – Connects to a TV or VCR
3
DIGITAL AUDIO OPTICAL – Connects to a digital A/V receiver
(optional)
4
AUDIO OUT TO TV – RCA stereo outputs (R/L) that connect to your
TV
5
AUDIO OUT TO VCR – RCA stereo outputs (R/L) that connect to
your VCR
6
DATA – Serial data interface (check with your service provider
before connecting any device to this port)
7
SMART CARD – Supports a Smart Card device (currently not
enabled)
8
AC POWER – A two-plug AC power inlet used to power the
QIP2500 (bottom) and another device (top), such as a TV or VCR
9
S-VIDEO – Connects to S-Video input of TV or VCR
10
VIDEO – RCA video output that connect to a TV, VCR, or other
device
11
DIGITAL AUDIO COAX – Connects to a digital A/V (audio/video)
receiver
12
USB – Connects to select USB 1.1 devices (check with your
service provider before connecting any device to this port)
13
IR – Connects the optional Infrared (IR) blaster attachment
14
TV PASS CARD – For future use
To Next Page
Loading...
