54
PROGRAMMING FEATURES
will either show ‘Pass’ or ‘Fail’ on the display (a
tone will be heard within 5 s).
5. Once you have completed the cloning process,
turn the radios OFF and ON or, long press the
PTT button to exit the ‘cloning’ mode.
Further details on how to clone radios are explained in
the Instructions Sheet provided with the MUC.
When ordering the MUC, refer to P/N# RLN6309_.
Notes:
• If cloning fails, refer to “What To Do If Cloning
Fails” on page 55.
• Paired Target radios and Source radios must be
of the same band type in order for the cloning to
run successfully.
• MUC pockets numbers should be read from left to
right with the Motorola Solutions logo facing front.
Cloning Radio using the Radio to Radio
(R2R) Cloning Cable (Optional Accessory)
Operating Instructions
1. Before starting the cloning process, make sure
you have:
• A fully charged battery on each of the radios.
• Two Single-Unit Chargers (SUC).
• Turn OFF the radios and,
• Both radios are of the same radio model.
2. Unplug any cables (power supply or USB
cables) from the SUCs.
MN002895A01_final.book Page 54 Thursday, January 5, 2017 10:51 AM
To Next Page
Loading...
Need help?
General
