Configuration Guide
PN: 1725-36197-001_A.doc
8
Installing the AP license through the CLI
For the RFS6000 to adopt AP300s, a license has to be installed. Obtain
the license key and then install based on the following steps:
RFS6000>en
RFS6000#conf t
RFS6000(config)#license AP <LICENSE_KEY>
Installing the AP license through the Web interface
1. Open the RFS6000 applet by entering the IP address of the
wireless switch: http://192.168.2.103
2. In the navigation pane under
Switch, click Licenses.
3. Enter the
License Key and Feature Name as seen in the figure below.
4. Click the
Install button to install the license.
To Next Page
Loading...
Need help?
General
