Motorola SCOUTTRAINER25 - Step 1: Installing the Simulator and Debugger Software

Step 1: Installing the Simulator and Debugger Software
2-4
2.2 Step 1: Installing the Simulator and Debugger Software
This section explains how to install the simulator and debugger software on
your hard-disk system. The software package is shipped on a CD-ROM. To
install the software, you must mount the CD-ROM, copy the files, and unmount
the CD-ROM.
Mounting the CD-ROM
Note: Root Privileges
If you are running SunOS 4.1.x, 5.0, or 5.1, you
must have root privileges to
mount the CD-ROM. If you don’t, get help from your system administrator.
The steps to mount the CD-ROM vary according to your operating-system
version:
- If you have SunOS 4.1.x, load the CD-ROM into the drive and enter the
following from a command shell:
mount –rt hsfs /dev/sr0 /cdrom
exit
cd /cdrom/sparc
- If you have SunOS 5.0 or 5.1, load the CD-ROM into the drive and enter
the following from a command shell:
mount –rF hsfs /dev/sr0 /cdrom
exit
cd /cdrom/cdrom0/sparc
- If you have SunOS 5.2 or higher:
J If your CD-ROM drive is already attached, load the CD-ROM into the
drive and enter the following from a command shell:
cd /cdrom/cdrom0/sparc
J If you do not have a CD-ROM drive attached, you must shut down your
system to the PROM level, attach the CD-ROM drive, and enter the
following:
boot –r
After you log into your system, load the CD-ROM into the drive and
enter the following from a command shell:
cd /cdrom/cdrom0/sparc