8 Getting started
2. Clip the battery cover back into place.
3. If you are charging the batteries for the rst time, place the handset on the base to
charge for at least 24 hours continuously.
4. When the handset is fully charged,
icon will appear steady on the display. Plug
the other end of the telephone line cord (make sure that one end is already plugged
into the base) into the telephone wall socket.
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for all the
handsets and chargers.
1. Plug the power adaptor into the socket marked
on the rear of the charger and plug
the other end into the mains power wall socket.
2. Remove the battery cover from the back of the handset and insert the 2 x AAA NiMH
rechargeable batteries supplied. Please note the ’+’ and ’-’ markings inside the battery
compartment and insert in the correct direction.
3. Clip the battery cover back into place.
4. If you are charging the batteries for the rst time, place the handset on the charger to
charge for at least 24 hours continuously.
5. When the handset is fully charged, the
icon will appear steady on the display. The
display will show
HANDSET
and handset number (e.g. 2) to indicate that it is registered
to the base.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH 450mA
rechargeable batteries) supplied with your S12.
Please do not use alkaline or non rechargeable batteries. It may cause permanent
damage to the product and void the warranty.
To Next Page
Loading...
Need help?
General
