9Getting started
BATTERY LOW WARNING
If the
icon flashes on the display and you hear a warning beep every minute during a
call, you will need to recharge the handset before you can use it again.
When charging, the
icon will scroll on the display.
Once fully charged scrolling will stop.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to 10 hours talk time or up to 200
hours standby time on a single charge.
1
Note that new batteries do not reach their full capacity until they have been put to normal
use for several days.
To keep your batteries in the best condition, leave the handset o the base for a few hours
at a time.
Running the batteries right down at least once a week will help them last as long as
possible.
The charge capacity of rechargeable batteries will reduce with time as they wear out,
giving the handset less talk / standby time. Eventually they will need to be replaced.
After charging your handset for the rst time, subsequent charging time is about 6–8 hours
a day. Batteries and handset may become warm during charging. This is normal.
1
All talk and standby times are approximate and depend on features selected and usage
pattern.
Date and time
If you have subscribed to a Caller ID Service, the date and time is set automatically for all
handsets when you receive your rst call.
If you do not have Caller ID service, you can set the date and time manually.
Set the date manually:
1. Press
m, scroll d to
DATE -- TIME
and press m.
The display shows
DATE SET
.
2. Press
mto select.
3. Enter the date (e.g. 12--08 for 12th of August) and press
mto conrm.
Set the time manually:
1. Press
m, scroll d to
DATE --TIME
and press m.
2. Scroll
d to
CLOCK SET
and press m.
3. Enter the time in 24 hour format (e.g. 18--30 for 6:30pm) and press
m to confirm.
Your S12 is now ready for use.
To Next Page
Loading...
Need help?
General
