How to fix can’t see the Motorola Symbol CS3000 Scanner drive?
If you can’t see the Motorola Scanner drive after connecting the scanner to the host, it might be mapping to a drive already in use. Use Windows’ map drive function to assign a different drive letter to the scanner.
Why Motorola Symbol CS3000 Scanner laser is on, but not decoding bar code?
If your Motorola Scanner's laser is on but it's not decoding bar codes, here's what to check: * First, make sure your scanner is set up to read the specific type of bar code you're scanning. * Next, examine the bar code itself to ensure it's clear and readable. If possible, try scanning known good test bar codes of the same type. * Finally, adjust the distance between the scanner and the bar code; move either closer or further away.
Why Motorola Symbol CS3000 Scanner LED turns solid red?
If the Motorola Scanner LED turns solid red briefly, it means the battery is low. To resolve this, charge the scanner's battery.
What to do if Motorola Scanner emits long beeps for 5 seconds?
If your Motorola Scanner emits long beeps for 5 seconds after scanning a bar code, it indicates that the memory is full. To fix this, download the bar code data to the host device and then clear the scanner's memory.
Why Motorola Symbol CS3000 does not fully charge?
If the Motorola Scanner does not fully charge, it might be because you're trying to charge it using a non-powered USB hub. Connect the scanner to a powered USB hub (5V, 500mA max) to resolve this issue.
To Next Page
General
