What to do if Motorola Barcode Reader digital scanner emits long low/long high beeps?
If your Motorola Barcode Reader digital scanner emits long low/long high beeps, it could be due to: * An input error: Scan the correct numeric bar codes within range for the parameter programmed. * A page timeout: Move the digital scanner back into range of the remote device, try to reconnect, and check the remote device configuration.
What does it mean when Motorola Symbol DS6878 digital scanner emits long low/long high/long low/long high beeps?
If your Motorola Barcode Reader digital scanner emits long low/long high/long low/long high beeps, it could indicate: * You are out of host parameter storage space: Scan Default Parameters. * You are out of memory for ADF rules: Reduce the number of ADF rules or the number of steps in the ADF rules. * The connection attempt was rejected by the remote device: Free up remote device resources.
What to do if Motorola Symbol DS6878 digital scanner emits low/high/low/high beep sequence while it is being programmed?
If your Motorola Barcode Reader digital scanner emits a low/high/low/high beep sequence while being programmed, it means you are out of ADF parameter storage space. Erase all rules and reprogram with shorter rules to resolve this.
Why does my Motorola Barcode Reader digital scanner battery require frequent charging?
Your Motorola Barcode Reader's digital scanner battery might need reconditioning. To resolve this, perform a battery reconditioning cycle.
What to do if Motorola Symbol DS6878 Barcode Reader digital scanner displays solid red LED longer than 3 seconds when placed in cradle?
If your Motorola Barcode Reader digital scanner displays a solid red LED for longer than 3 seconds when placed in the cradle, it might be because the battery requires pre-charge due to excessive discharge. Wait for the red LED to turn green, indicating that normal charging has begun. It's recommended to allow the battery to fully recharge.
What does it mean when Motorola Symbol DS6878 digital scanner emits high/high/high/low beeps?
If your Motorola Barcode Reader digital scanner emits high/high/high/low beeps, it indicates an RS-232 receive error. This is normal during host reset. Otherwise, set the digital scanner's RS-232 parity to match the host setting.
Instructions for inserting the battery into the scanner.
Guide to connecting the cradle cable to the host device.
Details on connecting the scanner to different host interfaces like RS-232, USB, and Keyboard Wedge.
Scanning bar codes to configure the scanner's host interface.
Understanding the different beep sounds for scanner status and operations.
Interpreting the LED light signals for scanner status, decoding, and transmission.
Steps to resolve issues when the scanner is not powering on or functioning.
Resolving issues where scanned data is not transmitted to the host.
Troubleshooting scenarios where the scanner fails to decode bar codes.
Addressing issues with scanned data being displayed incorrectly on the host.
Recommendations for optimal arm position and avoiding strain during use.
Configuring the scanner for radio communication with different host types.
Adding Enter or Tab keys as data suffixes for customized data entry.
Options for resetting to factory defaults and powering off the battery for storage.
General| Scanning Technology | Laser |
|---|---|
| Scan Rate | 100 scans per second |
| IP Sealing | IP42 |
| Model | DS6878 |
| Type | Handheld |
| Connectivity | Bluetooth |
| Operating Temperature | 32°F to 122°F (0°C to 50°C) |
| Storage Temperature | -40 to 60 °C |
| Scanner Type | Handheld |
| Scan Pattern | Omnidirectional |
| Decode Capability | 1D, 2D, PDF417 |
| Drop Spec | 6 ft (1.8 m) concrete |
To Next Page
