About Your Phone, Battery and SIM Card
17
English
Your Battery
Installing the Battery Pack
A new battery is supplied uncharged and fitted within a
protective battery carrier. To remove the battery, press the release
catch on the battery carrier and open the cover.
To install the batteries in your phone:
1
Press the release catch of the phone battery cover and slide
the battery cover towards the bottom of the phone.
2
Align the positive and negative (+ and -) connections on the
battery with the positive and negative (+ and -) connections
within the phone.
.
3
Press the battery towards the connections and push it
downwards until it clicks into place.
4
Replace the phone battery cover.
Important Battery Information
! Always treat your batteries with care. See ‘Batteries’, at
the beginning of this manual.
! Never leave your battery in extremely high
temperatures (over 60°C), for example behind glass in
very hot, direct sunlight.
! Only Motorola Original Accessory batteries can be
charged in the phone. This is to protect you and your
phone from the risks of incorrect charging.
Charging a New Battery
A new battery is supplied in a totally uncharged state.
To ensure maximum battery performance, a new battery (or
battery that has not been used for several months) should be
charged for at least 14 hours before use.
ADepending on the state of the battery, a phone call may not
be supported during charging. If the battery is low or nearly
depleted, it is recommended that you allow the battery to
charge before placing or receiving a call.
AA new battery will require several full charge/discharge
cycles in order to achieve its optimum performance.
AA new battery, or a battery that has not been used for
several months, may cause a premature fully charged
indication. Ignore this indication and let the battery charge
for several more hours, remove and re-insert the battery
into the charger, and charge for an additional 14 hours.
! Your battery will not charge if it is not matched properly
to the phone connection markings (+ and -). Please
ensure that you have installed the battery properly
before initiating a charge.
To Next Page
Loading...
