About Your Phone, Battery and SIM Card
17
English
Your Battery
Installing the Battery Pack
A new battery is supplied uncharged and fitted within a
protective battery carrier. To remove the battery, press the
release catch on the battery carrier and open the cover.
To install the battery in your phone:
1 Press the release catch of the
phone battery cover and slide the
battery cover towards the bottom
of the phone.
2 Align the positive and negative
(+ and -) connections on the
battery with the positive and
negative (+ and -) connections
within the phone.
3 Press the battery towards the
connections and push it
downwards until it clicks into
place.
4 Replace the phone battery cover.
Important Battery Information
! Always treat your batteries with care. See ‘Batteries’, at
the beginning of this manual.
! Never leave your battery in extremely high
temperatures (over 60˚C), for example behind glass in
very hot, direct sunlight.
! Only Motorola Original Accessory batteries can be
charged in the phone. This is to protect you and your
phone from the risks of incorrect charging.
Charging a New Battery
A new battery is supplied in a totally uncharged state.
To ensure maximum battery performance, a new battery
(or battery that has not been used for several months)
should be charged for at least 14 hours before use.
ADepending on the state of the battery, a phone call
may not be supported during charging. If the battery
is low or nearly depleted, it is recommended that you
allow the battery to charge before placing or receiving
a call.
AA new battery will require several full charge/discharge
cycles in order to achieve its optimum performance.
Angel.book Page 17 Monday, April 24, 2000 8:04 PM
To Next Page
Loading...
