Special Features
21
When the radio detects activity, it stops scanning and you can hear the
transmission on that channel. To respond and talk to the person transmitting,
press within 5 seconds.
To stop scanning, briefly press and release .
Note: If you press while the radio is scanning, the radio transmit on the channel
you selected before you activated scan. If no transmission occurs within 5
seconds, scanning will resume.
Scan Advance
If the radio stops scanning on a channel you do not want to listen to, briefly press
and release or to resume scanning for the next active channel.
Removing Channels from the Scan List (Nuisance Delete Feature)
To prevent the radio from scanning a channel, press and hold or for at
least 3 seconds, then release, when the scan first stops on that channel. This
temporarily removes the channel from the scan list. Press to exit scan mode.
Press a second time to activate scan again. To restore a previously deleted
channel, turn the radio off and then back on. The channel is now restored.
Note: You cannot remove your home channel from the scan list. The home
channel is the channel your radio was set to when you started the scanning.
To Next Page
Loading...
Need help?
General
