Motorola TETRA MTM800

36
Receiving a Group Call
Unless it is engaged in an active call, your MTM800 will
automatically switch to Group Mode and receive the
transmission. To answer the call, press and hold PTT.
Your MTM800 shows the Group Name, and the caller’s
private number or name (alias) if previously stored in your
address book. In case a favourite talkgroup is received, the
terminal will display the “My Groups” range and group alias.
The following screens show examples of how the caller’s
private number (ID 7712) is displayed.
Receiving a Group Call with Scan Off
You can receive a group call from the selected talkgroup or
from the associated ATG only.
Receiving a Group Call in Idle Mode
In Automatic Mode Switch you can receive
a Group Call in any mode. Your MTM800
will automatically switch into Group mode
and receive the transmission.
Receiving a Group Call during an On-going Group Call
Depending on how the Service Provider has configured
incoming calls, the incoming call will either be:
• Forced upon you and will interrupt the on-going call (if the
incoming call has higher priority than the on-going call).
For incoming call alert, see settings in the Tones menu option
(page 88)
.
When receiving a Group Call, your MTM800 will sound a “New
Group Call” tone (if configured by your Service Provider).
Private number
Private number
without alias
with alias
Status
Talkgroup 1
Status
Talkgroup 1
or
ID: 7712
ID: David
Without alias and
Private number
Status
Talkgroup 1
or
Range 1
Status
Group In Use
TG 4
6815321H01_KOR.book Page 36 Wednesday, November 26, 2008 1:25 PM