44
Selecting DMO Group Call MS to MS
To change from gateway or repeater mode to MS – MS mode
(DMO terminal to terminal call):
1. Press Optns, scroll to 3 Config, and press Ok.
2. Scroll to 1 MS – MS and press Ok. The
following message to be displayed for a
few seconds: MS – MS Will Be Used.
Selecting DMO Group Call via Gateway
While in DMO, proceed as follows to choose a gateway to set
up a call via Gateway for the selected talkgroup:
1. Press Optns, scroll to 3 Config, and press Ok.
2. Scroll to 2 Gateway and press Ok.
3. The display shows the last gateway selection method. Use
the navigation key to scroll to your selection and press Ok:
Automatic — the MTM800 will use the
first available gateway for that talkgroup.
The Gateway icon will blink upon
selecting that option.
Specific — the MTM800 will use only the gateway with the
specified Gateway address for that talkgroup.
Upon selecting “Specific”, you will see one of the following
displays:
• The selected gateway address (e.g.:
1022), pre-programmed by your Serv-
ice Provider or previously entered by
yourself via the keypad. Press Ok to
use the current address, or enter a new address via the
keypad, and press Ok. The Gateway icon will blink upon
selecting the gateway.
2 Gateway
1 MS – MS
4 GW + Rep
Back
Ok
1 MS – MS
2 Gateway
3 Repeater
Back
Ok
1 Automatic
2 Specific
Ok
Back
GW No: 1022
Will Be Used
6815321H01_KOR.book Page 44 Wednesday, November 26, 2008 1:25 PM
To Next Page
Loading...
