Motorola v3i - Removing and Replacing the Flip Assembly Cover

32 November 18, 2005 6809495A82-A
Disassembly V3i
Removing and Replacing the Flip Assembly Cover
1. Remove the battery cover, battery, SIM, antenna, rear housing, and
transceiver board assembly as described in the procedures.
2. Remove the 4 flip assembly screw caps.
3. Use the T-5 driver to remove the 4 T5 screws from the flip assembly (see Figure
11). Retain the screws for re-assembly.
4. Before removing the flip cover, note the locations of the smart buttons on the
sides of the flip assembly.
051128o
Figure 11. Removing the Flip Assembly Screws
Flip screws
Flip screws