Motorola Confidential Proprietary
Manual Test ProceduresLevel 3 Service Manual
2-11
Draft 1.0
Audio/Vibrator Test Procedures
This section describes how to use test commands to
verify audio and vibrate functions.
In order to successfully send test commands to the phone
under test, the phone needs to be in suspend mode.
Follow the listed procedure to place the phone in sus-
pend mode.
Click AT+MODE then SUSPEND
(Serial Only)
Click SUSPEND (USB Only)
Vibrator Test
Enable or Disable Vibrator
Verification
Verfiy vibration function when enabled.
Handset Mic/Speaker test
Set as illustrated.
Click Set
Select Enhanced Full Rate and
click Vocoder
Verification
Speak into the handset mic and listen for undistorted
speech in the handset speaker.
Mono Headset Mic/Speaker test
Set as illustrated
Click Set
Select Enhanced Full Rate and
click Vocoder
Verification
Speak into the headset mic and listen for undistorted
speech in the headset speaker.
Audio/Vibrator Test Procedures
To Next Page
Loading...
