Motorola V980 User Manual (English)

Other manuals for Motorola V980

Manual84 pages

Owner's Manual27 pages

Questions and Answers:

G
George DayAug 17, 2025
Why Motorola V980 will not turn on?
- T
  Taylor WareAug 17, 2025
  Your Motorola Cell Phone might not be turning on due to a discharged or defective battery. Try recharging the battery. If it doesn't recharge, it may need to be replaced. Another reason could be misaligned battery connectors. Check and realign them, and if necessary, replace the battery or seek assistance from a Level 3 Service Center. A defective transceiver board assembly or keyboard assembly failure can also prevent the phone from turning on, and in such cases, replacement of the corresponding assembly is required.
C
Christina MartinezAug 20, 2025
What to do if my Motorola V980 has poor reception?
- C
  cynthia38Aug 20, 2025
  If your Motorola Cell Phone is experiencing poor reception, frequently dropped calls, or weak/distorted audio, the antenna assembly might be defective. Check if the antenna pin is properly connected to the transceiver board assembly. If it is, try substituting it with a known good antenna. Another cause could be a defective transceiver board assembly, which would require replacement.
J
Joy ShieldsAug 23, 2025
What to do if Motorola V980 transmit audio is weak?
- V
  vasquezdaleAug 23, 2025
  If people have difficulty hearing you when you speak on your Motorola Cell Phone, the microphone connections to the transceiver board assembly might be defective. Check these connections. It could also be a defective microphone, in which case you should disconnect the current microphone and substitute it with a known good one to see if there's an improvement. The transceiver board assembly may also be defective, requiring replacement.
A
amymclaughlinAug 26, 2025
What to do if Motorola V980 receive audio is weak?
- J
  James MccannAug 26, 2025
  If the audio from the earpiece speaker on your Motorola Cell Phone is weak or distorted, check the connections to and from the transceiver board assembly, including the flex and flex connector from the flip assembly. The flip assembly itself might be defective, so try temporarily replacing it with a known good one. Also, ensure the antenna is installed correctly. Finally, the transceiver board assembly could be defective and need replacing.
N
Nicole IrwinAug 28, 2025
Why Motorola V980 internal charger not working?
- T
  taradorseyAug 28, 2025
  If the internal charger on your Motorola Cell Phone is not working, it could be due to a faulty charger circuit on the transceiver board assembly. Test a selection of batteries in the rear pocket of the desktop charger and check the LED display for charging indications.
C
chapmansusanAug 31, 2025
What to do if Motorola V980 Cell Phone display is erratic?
- M
  Matthew JonesAug 31, 2025
  If the display on your Motorola Cell Phone is erratic, partial, or completely blank, it could be due to faulty transceiver board connections. Remove the rear chassis assembly and check the condition of the flex cable. If the flex cable is in good condition, ensure that the flex connector is fully pressed down. Another potential cause is a defective flip assembly, which can be temporarily replaced with a known good assembly to test. A defective transceiver board assembly could also be the reason, requiring its replacement.
A
Ashley MaysSep 3, 2025
Why Motorola V980 will not recognize SIM?
- T
  Todd RomeroSep 3, 2025
  If your Motorola Cell Phone isn't recognizing the SIM card, start by checking the SIM contacts for dirt and clean them if necessary. If cleaning doesn't work, the flip assembly might be defective, and you can temporarily replace it with a known good assembly to test. The transceiver board assembly could also be the issue, requiring replacement.
J
Judy MayerSep 5, 2025
What to do if Motorola Cell Phone does not sense flip?
- R
  Robert SmithSep 5, 2025
  If your Motorola Cell Phone isn't sensing when the flip is opened or closed, it could be due to a defective flip assembly. Try temporarily replacing it with a known good assembly. Alternatively, the transceiver board assembly might be defective and require replacement.
S
Sheryl PughSep 8, 2025
What to do if incoming call alert transducer audio distorted on Motorola V980?
- J
  James NguyenSep 8, 2025
  If the incoming call alert transducer audio on your Motorola Cell Phone is distorted or the volume is too low, the transceiver board assembly might be faulty, requiring replacement.
J
Jacqueline CastilloSep 12, 2025
Why Motorola V980 vibrator feature not functioning?
- K
  Katelyn SchneiderSep 12, 2025
  If the vibrator feature on your Motorola Cell Phone is not functioning, the transceiver board assembly might be defective and require replacement.

Motorola V980 Specifications

General

Model	Motorola V980
Form Factor	Clamshell
Network Technology	GSM / UMTS
2G bands	GSM 900 / 1800 / 1900
3G bands	UMTS 2100
GPRS	Class 10
EDGE	Class 10
Status	Discontinued
SIM	Mini-SIM
Type	TFT, 256K colors
Resolution	176 x 220 pixels
Memory Card slot	No
Internal Memory	5 MB
Camera	VGA, 640 x 480 pixels
Video	Yes
Alert types	Vibration; Downloadable polyphonic, MP3 ringtones
Loudspeaker	Yes
3.5mm jack	No
Bluetooth	Yes
GPS	No
Radio	No
USB	Yes
Browser	WAP 2.0/xHTML
Games	Yes
Java	Yes, MIDP 2.0
Predictive text input	Yes
Organizer	Yes
Battery	Removable Li-Ion 820 mAh battery
Speed	Yes
Second display	Monochrome
Phonebook	Yes
Call records	20 dialed, 20 received, 20 missed calls
Messaging	SMS, MMS, Email
Stand-by	Up to 200 h
Size	2.2 inches, 35 x 45 mm