Level 1-2 Service Manual Disassembly
Aug.15, 2006 35
Remark
1. In the event the SIM Card warps after being inserted. (shown as Figure 42 below)
Figure 42.
2. Solution : The angle of insertion must be lower than the surface of the Shielding Can, when
the factory disassembles the Shielding Can to rework. (shown in the following figure)
Figure 43.
OK
NG
This shear plane must be lower
than that of Shielding Can.
the surface of
Shielding Can
To Next Page
Loading...
