44
basics
tap mode
Press
#
in a text entry screen to switch to
TAP mode. If you do not see
g
or
m
, press
M
>
Entry Setup
to set TAP mode as your
Primary
or
Secondary
text entry mode.
To enter text in TAP mode, press a keypad
key repeatedly to cycle through the letters
and number on the key. Repeat this step to
enter each letter.
For example, if you press
8
one time, your
phone displays:
After 2 seconds, the character is accepted
and the cursor moves to the next position.
numeric mode
In a text entry screen, press
#
to switch
entry modes until the
12
(numeric) indicator
is displayed.
Press keypad keys to enter the numbers you
want. When you finish entering numbers,
press
#
to switch to another entry mode.
symbol mode
In a text entry screen, press
#
to switch
entry modes until the
@
(symbol) indicator is
displayed.
Press keypad keys repeatedly to cycle
through its symbols. Highlight the symbol
you want, then press
SELECT
.
T
T
Press
OK
to
accept &
store text.
Press
DELETE
to
erase the
character to
left of insertion
point.
Character
displays at
insertion
point.
OK
DELETE
Message 765
ì
h
4
ã?
h
x
å
CFJN3329B.book Page 44 Thursday, November 9, 2006 3:41 PM
To Next Page
Loading...
