Motorola WAVE PTX TLK 110 - Bluetooth Device Management; Searching and Clearing Pairing

• Ensure the Bluetooth mode is on.
•
If required, update the Bluetooth accessory list in Wave OnCloud (WoC) portal.
Procedure:
From the menu, select Bluetooth Pairing Status.
Your radio shows the following indications:
• The display shows Bluetooth Searching.
• The voice announcement sounds.
If the Bluetooth device is connected to the radio, your radio shows the following indications:
• A positive tone sound.
• The display shows a positive mini notice.
• The voice announcement sounds.
NOTE:
If the connected Bluetooth device is out of range or tuned off, your radio shows the following
indications:
•
A negative tone sounds.
• The display returns to Bluetooth Searching.
24.3
Clearing Bluetooth Pairing
Procedure:
1 From the menu, select Bluetooth Pairing Status.
2 Scroll through the Bluetooth list using Volume Up
or Volume Down buttons.
3 On the selected device, press and hold the Menu/Programmable button to clear the pairing.
If the request is successful, a positive tone sounds.
If the request is unsuccessful, a negative tone sounds.
MN009326A01-AA
Chapter 24 : Bluetooth
52