CSD Series Variable Frequency AC Drive
MOTORTRONICS
- 59 -
7.5 Operation Error Indications
7.6 One Final Fault Note
If the circuit breaker did not trip, remove power, wait 1 minute, reapply
power and see if the trip condition clears. If the condition has not
cleared, replace the drive. When replacing fuses, CSD drives rated
240VAC > 2HP and all 480 VAC units have a DC bus line fuse. If the
fuse opens due to a fault condition on the output of the drive, care
must be used in replacing the fuse. ONLY USE THE EXACT FUSE IN
REPLACEMENT! MAKE SURE THE DC BUS IS TOTALLY
DISCHARGED BEFORE REPLACING THE FUSE! FAILURE TO
OBSERVE STANDARD SAFETY PRECAUTIONS COULD RESULT
IN INJURY OR DEATH!
To Next Page
Loading...
Need help?
General
