Page 4
Power Options (continued)
Clock Battery - This is a long life battery that
needs to be changed only when the clock fails to
keep proper time or user settings are lost. Replace
with CR2025 or equivalent.
Events - An event is when the infrared sensor detects movement. A picture is recorded
when the camera is activated by an event or manually in the Handheld mode. Each event
may cause still images or videos to be made. Note if you exceed the available memory
pictures will not be made, but events will be counted.
Page 7
SETTING FACTORY SETTING (Default) USER OPTIONS
Time Set Locally n/a
Date Set Locally n/a
Event Counter 0 Indicates number of times the IR sensor
was activated. May be reset as desired.
Image Capture Mode Still Still or Video
Still Image Quality Standard Standard or High
Image Delay 1 Minute 20 seconds to 60 minutes
Image Sequence 1 picture per event 1 - 2 - 3 - pictures per event
Erase images n/a Yes - No
Camera ID Blank 8 letters or numbers that will appear on
your pictures.
User Setup Sequence
System Setup
You can use the Quick Start method to set the system using factory installed settings
(Defaults). The system is fully functional for most applications after the battery has been
installed, the time & date have been set, and the system has been turned ON, or you can
put in custom settings as follows:
rcdezÿn_created-72004_rev-r291604_DigitalGameCam_InstructionManual_pages_7.4
3V BATTERY
Holder
Holder
Load battery in holder
Load battery and holder
in clock battery compartment
Operating the System
Laser Aiming (optional)
Use the Laser Aim or Infrared Test to
position camera as desired. Activate
the laser by pressing the Laser Aim
button. The LCD display will indicate
that the laser is ON.
Press the Laser Aim button again to
turn the laser off when not needed. The
laser will shut off automatically after
one minute.
Note: Aiming laser will function only in
SETUP and AUTO modes.
Laser Classification
Class II Laser Product
Wavelength: 650nm
Maximum Output: < 1mW
CAUTION: Looking into the laser
beam may be hazardous to the eyes.
Do not stare into the beam or direct it
towards other people unnecessarily.
CAUTION: Use of controls or
adjustments or performance of
procedures other than those specified
herein may result in hazardous
radiation exposure.
WARNING: Looking directly into the
beam with optical aids (e.g. binoculars,
telescopes) can be hazardous to the
eyes.
Warning and Aperture Label
Located next to laser aperture
ID/Certification Label
Located in battery chamber
Product complies with applicable
requirements of 21 CFR 1040.10
and 1040.11
LASER RADIATION
DO NOT STARE INTO BEAM
DIODE LASER
1mW MAX OUTPUT at 650 nm
CLASS II LASER PRODUCT
AVOID EXPOSURE: Laser radiation
is emitted from this aperture.
CAUTION
Model Number: 00094 60089 60099
Serial Number:
Manufacturer: Global Point Products, Farmington, NY 14425
This Product complies with applicable requirements of 21 CFR
1040.10 and 1040.11
No user serviceable parts inside.
Questions or Problems Contact:
Moultrie Customer Service
(205) 664-6700
150 Industrial Rd. Alabaster, AL 35007
+
To Next Page
Loading...
Need help?
General
