System Requirements
OS: Microsoft® Windows® XP with Service Pack 2
(Service Pack 3 recommended); Windows Vista® Home Premium,
Business, Ultimate, or Enterprise with Service Pack 1; or Windows 7
Hard disk space: 100MB or above
CPU: Intel® Pentium® 4 or AMD Athlon® 64 processor or above
Memory: 1GB of RAM
Operational Mode Auto - Game Detect / Video - 10 sec. AVI clips
Resolution 5.0 MP
Still Resolutions JPEG - Low 640x480, High 2560x1920
Video Resolutions AVI - 640x480 at 30FPS
Image Format USB OUT or SD Card
Response Time 1.2/1.5 seconds
Sensor 2.0 MP
Housing Weather-resistant and lockable
Display Liquid Crystal Display (LCD)
LCD Status Display Picture Count
Status LED Camera, or IR activity
SD Memory Card Up to 32 GB SD card (not included)
Format JPEG - Still pictures, AVI - Video: 10 second clips
USB Output Requires PC / MS Windows XP/Vista/7
Picture Delay Variable 1, 5, 10, 30 minutes
Standby Time 170 days
Run Time 90 days
Focus 5' - Infinity
Infrared Sensor Passive
Infrared Range Up to 40”
Flash Type 12 LED's 850nm
Flash Range 5' - 40'
Note When batteries become weak, the flash power is reduced to increase run time.
Upgradeable Software Yes
Easy Read Bar Camera ID / Date / Time
Power Supply 4 C-Cell Alkaline batteries (not included)
External Power port 12V
Size 7" x 5" x 2.5"
Factory Settings
PHOTO QUALITY: HIGH 2560 x 1920 FILE COUNT: 0001
TIME/DATE:
AM
12:00 2011/1/01
CAMERA ID: 1
Default/Easy Start
Specifications
4
Setup and Programming
Navigating Different Settings
During the (Setup) mode, you can program the
camera for different settings. The (Enter) button will
start the programming process when the selection
flashes. The (Up/Down) buttons will move from one
value to the next. The (Enter) button will then lock in
any selections. Then press the (Select) button again
to move to the next setting.
Turning Power ON/OFF
Open the camera cover. Turn the (Mode) switch to
the (Setup) position. Press and hold the (On/Off)
button until the time appears on the LCD display. If
you want to turn the unit off, press the (On/Off)
button once, the LCD shows “OFF” and then
goes off.
Note: If there is no activity for 2 minutes the
camera will shut off automatically to save
battery life.
Setting Time and Date
While the camera is in the (Setup) mode,
the LCD Display will show the time. Press
the (Enter) button and the selection will
flash. Use the (Up/Down) buttons to move
from one value to the next. Press the
(Enter) button to make the selection. Press
the (Select) button to move to the next
selection. Repeat the process to set the
year, month and day.
Reset Picture Count
After the camera’s time and date have been
set, you can reset the picture count on the
camera. Press the (Select) button until
(Clr) shows in the LCD display. Press
(Enter) button and use the (Up/Down)
buttons to choose between Yes or No.
(Yes) will reset file number to start
from 0001.
9
To Next Page
Loading...
Need help?
General
