QUICK START INSTRUCTIONS
B
12
SETTING PHOTO/VIDEO OPTIONS (cont.)
H
Setting Video Length
Choose between 5 video length settings (5, 10, 30, 60 or 90 seconds).
NOTE: Night videos are limited to a maximum of 30 seconds.
VIDEO LENGTH
10 SECONDS
MEMORY OPTIONS
I
Erase Images
Choose between Yes - erase all images, or No - does not change stored images.
NOTE: This will also format your SD card for use in your camera.
Managed Memory
Selecting the OVERWRITE OLDEST option will cause the oldest les to be overwritten with
new captures when the SD card reaches its capacity. With the DO NOT OVERWRITE option
selected, the camera will cease image capture once the SD card reaches capacity.
ERASE ALL IMAGES
NO
MANAGED MEMORY
DO NOT OVERWRITE
Use the steps below as a guide to quickly set up your camera so it will function using the factory default settings.
STEP 1
Open camera cover. Install eight (8) AA size alkaline or lithium batteries with polarities as indicated in the Battery Tray. Insert your SD card. We
recommend that you erase the SD card (ERASE IMAGES) inside the camera before taking pictures: this will not only erase all images, but will also
format your SD card for use in the camera. Camera will not operate without SD card. Switch camera to Quick Start.
STEP 2
Mount camera in desired location using a mounting strap. The camera also has two Python™
Cable Loops for added security. NOTE: Camera must be attached to a stable object for
motion detection to function properly. Mounting camera on an unstable structure may
result in excess image captures with no subject (false triggers).
STEP 4
Close cover. The camera will operate using Default settings. You may also
customize the settings if desired in Custom Start.
STEP 3
Switch camera to Aim. Aim camera using motion detection to determine
target area. Walk in front of the camera at the desired distance and the
camera LED will ash showing the covered area.
Eyelet
Mounting Strap
5
Setting Run Mode
When you choose Quick Start, the only settings
that you will be able to change will be Date and
Time, allowing for rapid setup. Other settings are:
OPTION SETTING
Mode Motion Detect
Detection Delay 30 seconds
Multi-Shot 3-Triggered
Photo or Video Photo
Python™ Cable
Loops
To Next Page
Loading...
Need help?
General
