Mountain Buggy swift - Safety Harness Operation; Fastening the Safety Harness; Releasing the Safety Harness; Adjusting Shoulder Strap Height

English
7
To fasten
Clip shoulder strap buckle ends into crotch plate.
To release
Pressredbuttons(ifpresentonyourmodel)andsqueezetabs
on either side of crotch plate to release shoulder straps.
To adjust shoulder straps height
1. Locate buckle by slipping hand up the inside back of
the seat.
2. Push the rectangular shaped buckle through the
insertion slot on an angle, pushing the corner of the
bucklerst.
3. Re-threadthecornerofthebucklethroughthemost
suitable height insertion slot for your child.
4. Oncethebuckleisthroughtheslot,twistitsoitisat
against the seat back and then check it is secure by
pulling on strap.
*
 Fornewerversions,twistandpushup/downthe
slider to the suitable height for your child.
To adjust harness length
Locate buckles inside shoulder pads and lift buckle up.
• Pullharnessstrapstolengthenharness
• Pullstrapendstoshortenharness
The buggy comes with the shoulder straps set to newborn position. Shoulder strap height should
be located just below or level with a child’s shoulders. The older the child, the further up the seat the
straps need to be.
red buttons
squeeze
WARNING: Use this harness at all times.
When not in use, disconnect shoulder
strapsfromthewaiststrapand/orbuckle
astheymaybeastrangulationhazard.
Safety Harness
*