14
EN
CONTROLS AND INSTRUMENTS
«SLOW» for minimum engine speed
«FAST» for maximum engine speed
– The «CHOKE» position ( if fitted instead of the 4.2 control) enriches the mixture
so must only be used for the time necessary when starting from cold.
– When moving from one area to another, put the lever in a position between «SLOW»
and «FAST».
– When cutting, go to the «FAST» position.
4.4 K
EY IGNITION SWITCH
This key operated control has three positions:
«OFF» everything is switched off;
«ON» activates all parts;
«START» engages the starter motor.
On being released at the «START» position, the key will automatically return to «ON».
4.5 P
ARKING BRAKE LEVER
This lever is to stop the machine from moving when it has been parked. There are two
positions:
«A» = Brake off
«B» = Brake engaged
– The brake is engaged by fully pressing the pedal (4.21 or 4.31) and moving the lever
to position «B». When you take your foot off the pedal it will be blocked by the lever
in the down position.
– A pilot lamp will warn that the brake is engaged (4.10.a).
– To disengage the parking brake, press the pedal (4.21 or 4.31). The lever will return
to position «A».
4.6 L
IGHT SWITCH
For turning on the lights when the key (4.4) is in the «ON» position.
➤
To Next Page
Loading...
Need help?
General
