39
EN
MAINTENANCE
6.4 DISMANTLING AND REPLACEMENT
6.4.1 R
EPLACING WHEELS
Stop the machine on a flat surface and put a block
under a load-bearing part of the frame on the side that
the wheel is to be changed.
The wheels are held by a snap ring (1) which can be
eased off with a screwdriver.
The rear wheels are directly coupled to the differential
axle shaft and fastened by a key that forms part of the
wheel's hub.
Should you substitute one or both rear wheels, ensure that they
are of the same diameter, and check that cutting deck is horizontal to prevent an
uneven cut.
Before re-fitting a wheel, smear some waterproof grease on the
axle and carefully re-fit the snap ring (1) and washer (2).
6.4.2 R
EPLACING AND REPAIRING TYRES
The tyres are of the «Tubeless» type and therefore all puncture repairs will have to be
carried out by a tyre-repair expert in accordance
with the methods for this kind of tyre.
6.4.3 R
EPLACING BULBS
The bulbs (18W) have a bayonet fitting and are
installed in the bulb holder which can be taken
out by turning it anti-clockwise, using pliers.
IMPORTANT
NOTE
2
1
To Next Page
Loading...
Need help?
General
